Connectors and Indicators
Controller connectors
Connector | Name | Function |
1 | Camera | Connects the controller to the camera. |
2 | Power/IO | Connects the breakout cable which provides power as well as connections to the input trigger and output. |
3 | Ethernet | Connects the controller to the network. |
Breakout cable pin-out
Pin | Signal Name | Wire Color |
1 | Power | Red |
2 | Ground | Black |
3 | Input Trigger | Green |
4 | Input Common | White |
5 | Output | Blue |
6 | Output Common | Gray |
Note - A 5ft USB cable is included for camera to controller connectivity. Note that this is a high-performance cable specially designed for Samsara Machine Vision. For optimal performance, we do not recommend using other USB cables. Please factor in this cable length when considering installation options.
Power
Power | 10V to 17V |
Triggering input | NPN/PNP supported |
Triggering voltage | ON: 10V to 30V DC OFF: 0V to 3V DC |
Output | NPN/PNP supported |
Output voltage | 30V DC maximum through external load |
Output current | 100mA maximum sink current |
External illumination | External illumination requires 24V power, contact Samsara for options |
Wiring Steps
1) Connect breakout cable to controller and wire the red (POS+) and black (NEG-) wires to the correct terminals on the unplugged power supply.
2) Connect the controller to the camera using the camera cable.
3) Connect the controller to an active internet connection via ethernet.
Once your controller is powered up and connected to ethernet you will see the indicator light illuminate green (the controller can take up to 2-3 minutes to sync)
Note: Contact Samsara if you would like to receive units pre-configured with Wi-Fi credentials.
Comments
0 comments
Please sign in to leave a comment.