The Samsara VS-series machine vision system is a complete solution for streamlining quality control across the factory floor. Once the system is installed, it can be programmed and updated remotely via the Samsara dashboard. This section of articles will walk you through the steps for deploying the system.
Note - A 5ft USB cable is included for the camera to controller connectivity. Note that this is a high-performance cable specially designed for Samsara Machine Vision. For optimal performance, we do not recommend using other USB cables. Please factor in this cable length when considering installation options.
Controller: 105 x 152 x 48mm (4.1 x 6.0 x 1.9 inches)
Controller: UV-stabilized polycarbonate, aluminum
|Ingress protection||IP67, camera, controller, and cable connections are all washdown-rated|
Power/IO, Camera: Bayonet-locking, IP67
|Integrated illumination||White LEDs (5000K)|
|Working distance||152 to 280mm (6 to 11 inches)|
|Field of view||
145 x 105mm at 152mm (5.7 x 4.1 inches at 6 inches)
Your VS2 kit will contain the following
(1) AC Power Supply
(1) Ethernet Enclosure Connection
(3) bags of mounting bolts (labeled 1, 2 and unlabeled)
(1) VS2 Gateway with mounting bracket
(1) VS2 Camera with mounting bracket
(2) Cables - USB-to-USB (1) & 6-pin M connector to pigtail
To power up and activate your hardware, please follow the guides linked below.
To get started on setting up your programs and inspections, check out the Getting Started with Machine Vision video playlist.
Please feel free to reach out to your sales representative or email@example.com if there are any questions or issues in deployment.